Test:handler:comp; Test:handler:keylock - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:TEST:HANDler:COMP

Syntax :TEST:HANDler:COMP {PHI|PLO|SREJ|OFF}
Description This command sets the Handler Comparator Function value for test purpose
and can be used to check/troubleshoot the Test pin signal of Handler
interface. (No query)
When
can be controlled/read by: TEST:HAND:xxxx commands. After completing
the test,
pin signal is generated according to the actual measurement result.
Related commands
:TEST:HANDler:BIN

:TEST:HANDler:KEYLock?

:TEST:HANDler:MODE
Equivalent key No equivalent key is available on the front panel.
sequence
:TEST:HANDler:KEYLock?
Syntax :TEST:HANDler:KEYLock?
Description This command gets the Handler/Key_Lock signal level for test purpose and
can be used to check/troubleshoot the Test pin signal of Handler interface.
(Query only)
When
can be controlled/read by: TEST:HAND:xxxx commands. After completing
the test,
pin signal is generated according to the actual measurement result.
{1|0}<newline><^END>
Query Response
Related commands
:TEST:HANDler:BIN
:TEST:HANDler:COMP
:TEST:HANDler:MODE
Equivalent key No equivalent key is available on the front panel.
sequence
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
:TEST:HANDler:MODE
:TEST:HANDler:MODE
on page 288
on page 289
on page 290
:TEST:HANDler:MODE
:TEST:HANDler:MODE
on page 288
on page 289
on page 290
is set to ON, the interface pin signal value
should set to OFF so that handler interface
is set to ON, the interface pin signal value
should set to OFF so that handler interface
289