Selecting Cable Length; Setting Up Averaging Function; Setting Up Trigger Delay Time; Setting Up Source Delay Time - Keysight E4981A Programming Manual

Setting Up Measurement Conditions and Display
Setting Up Measurement Conditions

Selecting cable length

To set the cable length (0 m/1 m/2 m), use the following command.
•

Setting up averaging function

Turning ON/OFF averaging function
To turn ON/OFF the averaging function, use the following command.
•
Setting up averaging count
To set the averaging count, use the following command.
•

Setting up trigger delay time

To set the trigger delay time, use the following command.
•

Setting up source delay time

To set the source delay time, use the following command.
•

Setting trigger sync source

To set the trigger sync source, use the following command.
•

Setting Signal Level Compensation (SLC)

To set the signal level compensation (SLC), use the following command.
•

Sample program

See
and LCD display.
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
:CALibration:CABLe[:LENGth]
[:SENSe]:AVERage[:STATe]
[:SENSe]:AVERage:COUNt
:TRIGger:SEQ2:DELay
:TRIGger[:SEQ1]:DELay
:SOURce:VOLTage:MODE
:SOURce:VOLTage:ALC[:STATe]
Example 9-1 to view an example of setting up measurement conditions
on page 171
on page 233
on page 232
on page 306
on page 303
on page 269
on page 267
43