[:Sense][:Fimpedance]:Creject[:State] - Keysight E4981A Programming Manual

Command Reference
E4981A SCPI Commands
Related commands

[:SENSe][:FIMPedance]:CREJect[:STATe]

[:SENSe][:FIMPedance]:RANGe[:UPPer]
[:SENSe][:FIMPedance]:RANGe:AUTO
Equivalent key [Meas Setup] - LOW C REJ - INCR+|DECR-
sequence
[:SENSe][:FIMPedance]:CREJect[:STATe]
Syntax [:SENSe][:FIMPedance]:CREJect[:STATe] {ON|OFF|1|0}
[:SENSe][:FIMPedance]:CREJect[:STATe]?
Description Enables/disables the Low C reject function.
When you enable the Low C reject function, if the measured value of the
primary parameter (Cp or Cs) is too small (equal to or less than the boundary
value specified with the
command), Low C is detected. For information on the screen display,
GPIB/USB/LAN output, and so on when Low C is detected, refer to Appendix
D, "Operations when Overload, No Contact, or Low C is Detected,".
Parameters
ON or 1
OFF or 0 (initial
value)
Query response {1|0}<newline><^END>
Related commands
[:SENSe][:FIMPedance]:CREJect:LIMit
Equivalent key [Meas Setup] - LOW C REJ - ON|OFF
sequence
264
[:SENSe][:FIMPedance]:CREJect:LIMit
Description
Enables the Low C reject function.
Disables the Low C reject function.
Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
on page 264
on page 266
on page 265
on page 263