Cam Sprocket/Camshaft/Rocker Arm Installation; Installation - Honda NSS250S Manual

CYLINDER HEAD/VALVES
Install the O
and bolt.
Tighten the bolts securely.
Install the O
Connect the O
Install the following:
– Cam sprocket (page 9-22)
– Exhaust pipe/muffler (page 3-33)
– ECT sensor 3P (Gray) connector (page 6-92)
Fill and bleed the coolant system (page 7-6).
CAM SPROCKET/CAMSHAFT/ROCKER
ARM INSTALLATION
CAMSHAFT/ROCKER ARM

INSTALLATION

Apply molybdenum oil solution to the rocker arm
Do not exchange
shaft sliding surface and rocker arm inner surface,
the intake and
boss rolling surface and slipper surface.
exhaust rocker arm
shafts.
Clean the rocker arm shaft holes and camshaft bear-
ing mating area.
Install the rocker arms and side springs as shown.
Install the rocker arm shafts to the cylinder head.
Install the rocker
arm shafts with the
• Install the rocker arms and rocker arm shafts in
cut-out facing rear
their original positions.
side.
9-22
maxiscooter-club.ru
sensor connector/fuel feed hose stay
2
sensor cord to the clamp.
2
sensor 1P (Black) connector.
2
BOLTS
O SENSOR CORD
2
CLAMP 1P (Black) CONNECTOR
ROCKER ARMS
ROCKER ARM SHAFTS
ROCKER ARM SHAFTS
SIDE SPRINGS
STAY
ROCKER ARMS