Honda NSS250S Manual page 386

ALTERNATOR/STARTER CLUTCH
Install the right crankcase cover to the right crank-
The alternator cover
case by aligning the tab of the water pump shaft
(stator) is
with the groove of the oil pump driven sprocket
magnetically
bolt.
attracted to the
flywheel, be careful
during installation.
Install the bolts with the clamp and tighten the bolts
in a crisscross pattern in two or three steps.
Install the bolt/washers to the air cleaner housing
and tighten them to the specified torque.
TORQUE: 11 N·m (1.1 kgf·m, 8 lbf·ft)
Connect the water hose to the water pump cover.
Install the clip and hose band screw securely.
Tighten the hose band screw properly (page 4-13).
13-6
maxiscooter-club.ru
Align
BOLTS RIGHT CRANKCASE COVER
AIR CLEANER HOUSING
CLIP
HOSE BAND SCREW
BOLT/WASHERS
WATER HOSES