Honda NSS250S Manual page 666

Honda S Matic System (NSS250A)
DTC11-1 (VS sensor no pulse)
• Before starting troubleshooting, check for loose
or poor contacts on the following connectors,
then recheck.
– VS sensor 3P (Black) connector
– PCM 33P (Black) connector
1. System Inspection
Place the scooter on its center stand.
Start the engine, open the throttle slightly and
check if the speedometer goes up.
Does the speedometer operate normally?
YES
NO
2. VS Sensor Input Line Continuity Inspection
Disconnect the PCM 33P (Black) connector (page
6-102).
Disconnect the VS sensor 3P (Black) connector
(page 22-20).
Check the continuity between the PCM 33P and
VS sensor 3P connectors of the wire side.
TOOL:
Test probe
CONNECTION: Pink/green – Pink/green
Is there continuity?
YES
NO
3. VS Sensor Input Line Short Circuit Inspection
Check the continuity between the PCM connec-
tor of the wire side and ground.
CONNECTION: Pink/green – Ground
Is there continuity?
YES
NO
24-22
maxiscooter-club.ru
– GO TO STEP 2.
– Inspect the speedometer and VS sensor
(page 22-18).
07ZAJ-RDJA110
– GO TO STEP 3.
– Open circuit in Pink/green wire
– Short circuit in Pink/green wire
– Replace the PCM with a known good
one, and recheck.
3P CONNECTOR
(Wire side/female terminals)
Pink/green
PCM 33P CONNECTOR
(Wire side/female terminals)
3P CONNECTOR
(Wire side/female terminals)
Pink/green
Pink/green