Honda NSS250S Manual page 702

Honda S Matic System (NSS250A)
REDUCTION GEAR INSTALLATION
Install the reduction gear A.
Install the gear A holder aligning its hole with the
crankcase boss.
Tighten the bolts.
Install the reduction gear B.
Install the ratio control gear holder and tighten the
bolts.
Install the movable drive face position sensor (page
24-58).
MOVABLE DRIVE FACE POSITION
SENSOR SHAFT INSTALLATION
Make sure that the movable drive gear boss con-
tacts with the pivot boss.
Install the movable drive pulley (page 11-25).
24-58
maxiscooter-club.ru
BOLTS REDUCTION GEAR A
REDUCTION GEAR A
REDUCTION GEAR B
BOLTS
Contact
ENGINE
SIDE
MOVABLE DRIVE FACE
Align
GEAR A HOLDER
GEAR HOLDER