Brake System - Honda NSS250S Manual

Hide thumbs Also See for NSS250S:

Table of Contents

REAR BRAKE PADS

Check the brake pads for wear.

Replace the brake pads if either pad reaches the bot-

tom of wear limit groove.

For the rear brake pad replacement (page 17-15)

Always replace the

brake pads as a set

to assure even disc

BRAKE SYSTEM

HYDRAULIC SYSTEM INSPECTION

Firmly apply each brake lever, and check that no air

has entered the system.

If the lever feels soft or spongy when operated,

bleed the air from the system (page 17-7).

Inspect the brake hoses and fittings for deteriora-

tion, cracks, damage or signs of leakage.

Tighten any loose fittings to the specified torque.

Brake pipe joint nut:

14 N·m (1.4 kgf·m, 10 lbf·ft)

Brake hose oil bolt:

34 N·m (3.5 kgf·m, 25 lbf·ft)

Replace hoses and fittings as required.

CBS INSPECTION

This model is equipped with a CBS.

Check the rear brake operation as follows.

Support the scooter on its center stand.

Jack up the scooter to raise the front wheel off the

Apply the left brake lever.

maxiscooter-club.ru

WEAR LIMIT GROOVES

NSS250A shown:

Table of Contents