Honda NSS250S Manual page 347

maxiscooter-club.ru
INSPECTION
DRIVE BELT
Check the drive belt for cracks, separation or abnor-
mal or excessive wear.
Measure the drive belt width.
SERVICE LIMIT: 25.5 mm (1.00 in)
Replace the drive belt if necessary.
SLIDE PIECE
Check the slide pieces for roughness, wear or dam-
age.
Replace the slide pieces if necessary.
REDUCTION GEAR B
Check the reduction gear B for wear or damage.
Replace the reduction gear B if necessary.
DRIVE PULLEY FACE BOSS A
Measure the drive pulley face boss A O.D.
SERVICE LIMIT:
O.D.: 35.44 mm (1.395 in)
Replace the movable drive pulley assembly if drive
pulley face boss A is out of service limit.
DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
DRIVE BELT
SLIDE PIECES
25.5 mm (1.00 in)
11-19