Honda NSS250S Manual page 496

HYDRAULIC BRAKE
ASSEMBLY
12 N·m (1.2 kgf·m, 9 lbf·ft)
5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
17 N·m (1.7 kgf·m, 13 lbf·ft)
STOPPER RING
• Be sure that each parts is free from the dust or
dirt before reassembly.
Coat new piston seal whole surface with clean brake
fluid.
Coat new dust seal whole surface with silicone
grease.
Install the piston seals and dust seals into the seal
grooves in the caliper cylinder.
Coat the caliper piston outer surface with clean
brake fluid and install them into their original loca-
tions with the opening sides toward the pads.
17-30
maxiscooter-club.ru
CALIPER PIN BOOT
RETAINER
BRACKET PIN BOOT
CALIPER BRACKET
PISTON SEALS
PISTON SEALS
BRAKE PADS
CALIPER PISTONS
DUST SEALS
PAD SPRING
DUST SEALS
PISTONS