Honda NSS250S Manual page 416

CRANKCASE/CRANKSHAFT/BALANCER
Install the right crankcase on the left crankcase.
Install the bolts with wire harness stay.
Tighten the bolts in a crisscross pattern in two or
three steps.
Apply oil to the following:
– Camshaft timing sprocket teeth
– Cam chain whole surface
– Oil pump drive chain whole surface
Install the oil pump drive chain onto the timing
sprocket.
Install the cam chain onto the timing sprocket.
Install the cam chain tensioner and bolt.
Tighten the cam chain tensioner bolt to the speci-
fied torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Apply grease to the main stand shaft sliding sur-
face.
Fill the main stand pivot with 3 g (0.1 oz) minimum
of grease.
Install the center stand, shaft and washer.
Install a new cotter pin to the center stand shaft
holes.
Bend the tips of the cotter pin securely.
14-22
maxiscooter-club.ru
RIGHT CRANKCASE
LEFT CRANKCASE
STAY
BOLTS
BOLT CAM CHAIN TENSIONER
OIL PUMP DRIVE CHAIN
LEFT SIDE: RIGHT SIDE:
SHAFT
WASHER
CAM CHAIN
COTTER PIN