Sensor Unit - Honda NSS250S Manual

FUEL SYSTEM (PGM-FI)
Install the injector/joint assembly to the intake pipe,
being careful not to damage the seal ring.
Install and tighten the bolts securely.
Install the clamp to the stay.
Connect the injector 2P (Gray) connector.
Install the luggage lower box (page 3-16).

SENSOR UNIT

REMOVAL
Remove the luggage lower box (page 3-16).
Disconnect the 5P (Black) connector.
Remove the torx screws and sensor unit.
Remove the O-ring from the throttle body groove.
6-88
maxiscooter-club.ru
BOLTS
INJECTOR/JOINT ASSEMBLY
STAY
CLAMP 2P (Gray) CONNECTOR
5P (Black) CONNECTOR
TORX SCREWS
O-RING
STAY
SENSOR UNIT