Honda NSS250S Manual page 339

Install the left crankcase cover and bolts, and
tighten them in a crisscross pattern in two or three
steps.
Clamp the wire to the clamps.
Clamp the rear wheel speed sensor wire to the
NSS250A:
clamp.
Install the left side front cover and tighten the socket
bolts to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Install the left floor step (page 3-12).
Install the left side rear cover (page 4-15).
DRIVE PULLEY (NSS250S)
REMOVAL
Remove the left crankcase cover (page 11-7).
Hold the drive pulley face with a special tool and
loosen the drive face bolt.
TOOL:
Universal holder
Remove the drive face bolt, washer and collar.
maxiscooter-club.ru
07725-0030000
DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
BOLTS
WIRES
CLAMPS
BOLTS
UNIVERSAL HOLDER
LEFT CRANKCASE COVER
CLAMP
REAR WHEEL
SPEED SENSOR
LEFT FRONT SIDE COVER
BOLT/WASHER/COLLAR
11-11