LEFT CRANKCASE COVER
REMOVAL
Remove the left side rear cover (page 4-15).
Remove the left floor step (page 3-12).
Remove the socket bolts and left side front cover.
Unhook the wires from the clamps.
Unhook the rear wheel speed sensor wire from the
NSS250A:
clamp.
Remove the bolts in a crisscross pattern in two or
three steps.
Remove the left crankcase cover.
Remove the dowel pins.
Remove the rubber seal.
maxiscooter-club.ru
DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
BOLTS
WIRES
CLAMPS
BOLTS
DOWEL PIN
RUBBER SEAL
LEFT SIDE FRONT COVER
CLAMP
REAR WHEEL
SPEED SENSOR
LEFT CRANKCASE COVER
DOWEL PIN
11-7