Inner Cover - Honda NSS250S Manual

INNER COVER

REMOVAL/INSTALLATION
Remove the following:
– Rear meter panel (page 3-22)
– Floor step (page 3-12)
– Console box (page 3-24)
Disconnect the console box lock release actuator 2P
(Gray) and LF antenna 2P (Natural) connectors.
Remove the trim clip B and front actuator cover.
Disconnect the mechanical key cable, seat lock
cable and console box lock cable from the actuator
stay.
Remove the screws and front actuator stay.
Remove the screws and LF antenna.
Remove the nut and parking brake lever.
Remove the bolt/washer.
Remove the inner cover by releasing the tab of the
Be careful not to
lower side inner cover from the hole of the frame
damage the bosses
and bosses of the front side inner cover from the
and holes.
holes of the grommet.
Installation is in the reverse order of removal.
Route the cables
properly (page 1-
TORQUE:
21).
Parking brake lever nut:
30 N·m (3.1 kgf·m, 22 lbf·ft)
• When installing the console box, make sure that
the console box lock release switch of the con-
sole box locked and unlocked.
maxiscooter-club.ru
FRAME/BODY PANELS/EXHAUST SYSTEM
BOX ACTUATOR 2P CONNECTOR
LF ANTENNA 2P CONNECTOR
SCREWS
LF ANTENNA
MECHANICAL
KEY CABLE
SCREWS
SEAT LOCK CABLE
INNER COVER
BOSS
BOLT/WASHER
TRIM CLIP B
COVER
BOX LOCK
CABLE
STAY
HOLE
NUT
PARKING BRAKE LEVER
3-27