Handle Lock Module - Honda NSS250S Manual

HANDLE LOCK MODULE

Honda Smart Card Key INDICATOR
INPUT VOLTAGE LINE INSPECTION
(WITH TEST PROBE)
INDICATOR DOES NOT COME ON
Remove the screen garnish (page 3-18).
Short the combination meter 28P (Gray) connector
of the wire side and ground using a jumper wire.
CONNECTION: Yellow/white – Ground
The indicator should illuminate when the ignition
switch is turned ON.
If the indicator does not illuminate, check the follow-
ing:
Disconnect the handle lock module 21P (Black) con-
nector (page 23-26).
Measure the voltage between the handle lock mod-
ule 21P connector of the wire side and ground using
a special tool.
TOOL:
Test probe
CONNECTION: Yellow/white (+) – Ground (–)
There should be battery voltage at all times without
approx. two seconds while the indicator is illumi-
nated after the ignition switch is turned ON.
If the battery voltage does not appear, check for
open circuit in Yellow/white wire.
If the battery voltage appears, faulty handle lock
module.
INDICATOR STAYS ON
Disconnect the handle lock module 21P (Black) con-
nector (page 23-26).
Check the continuity between the handle lock mod-
ule 21P connector of the wire side and ground.
TOOL:
Test probe
CONNECTION: Yellow/white – Ground
If there is continuity, check for short circuit in Yel-
low/white wire.
There is no continuity, faulty combination meter.
maxiscooter-club.ru
07ZAJ-RDJA110
07ZAJ-RDJA110
Honda Smart Card Key System
COMBINATION METER 28P CONNECTOR
(Wire side with connector connected)
Yellow/white
HANDLE LOCK MODULE 21P CONNECTOR
(Wire side/female terminals)
Yellow/white
HANDLE LOCK MODULE 21P CONNECTOR
(Wire side/female terminals)
Yellow/white
23-19