Honda NSS250S Manual page 351

Remove the socket bolts, stopper arm and O-ring.
Remove the drive pulley face boss B.
Remove the oil seal.
Check the movable drive face spline collar for wear
or damage.
Measure the drive pulley face boss B O.D.
SERVICE LIMIT:
O.D.: 34.95 mm (1.376 in)
Replace the movable drive pulley assembly if drive
pulley face boss B is out of service limit.
ASSEMBLY
SPLINE COLLAR
OIL SEAL
BOSS B
STOPPER ARM
maxiscooter-club.ru
MOVABLE DRIVE PULLEY FACE
OIL SEAL
O-RING
SLIDE PIECES
STOPPER PLATE
DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
SOCKET BOLTS
STOPPER ARM/O-RING
SPLINE COLLAR
10 N·m (1.0 kgf·m, 7 lbf·ft)
DUST SEAL
SCREW GEAR
10 N·m (1.0 kgf·m, 7 lbf·ft)
DRIVE PULLEY FACE BOSS B
OIL SEAL
BOSS B
O-RING
10 N·m (1.0 kgf·m, 7 lbf·ft)
SCREW HOLDER
BEARING SNAP RING
11-23