Service Information - Honda NSS250S Manual

SERVICE INFORMATION

GENERAL
• A halogen head light bulb becomes very hot while the head light is on, and remains hot for awhile after it is turned off.
Be sure to let it cool down before servicing.
• Note the following when replacing the halogen headlight bulb.
– Wear clean groves while replacing the bulb. Do not put fingerprints on the headlight bulb, as they may create hot
spots on the bulb and cause it to break.
– If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to prevent its early failure.
– Be sure to install the dust cover after replacing the bulb.
• Use an electric heating element to heat the water/coolant mixture for the ECT sensor inspection. Keep flammable mate-
rials an electric heating element. Wear protective clothing, insulated gloves and eye protection.
• Check the battery condition before performing any inspection that requires proper battery voltage.
• A continuity test can be made with the switches installed on the scooter.
• For turn signal removal/installation (page 3-22)
• For rear combination light removal/installation (page 3-23)
• For license light removal/installation (page 3-31)
• Route the wires and cables properly after servicing each component (page 1-21).
• The following color codes used are indicated through out this section.
Bu = Blue G = Green
Bl = Black Gr = Gray
Br = Brown Lb = Light blue
SPECIFICATIONS
Bulb Headlight
Position light
Brake/tail light
License light
Front turn signal light
Rear turn signal light
Luggage box light (NSS250A)
Instrument light
Instrument needle light
Turn signal indicator
High beam indicator
Parking brake indicator
MIL
Oil pressure indicator
Honda smart card key indicator
ABS warning indicator (NSS250A)
S mode indicator (NSS250A)
D mode indicator (NSS250A)
A/M mode indicator (NSS250A)
Fuse NSS250S
NSS250A
maxiscooter-club.ru
Lg = Light Green
O = Orange
P = Pink
ITEM
High (Right)
Low (Left)
Main fuse
Sub fuse
Main fuse
Sub fuse
LIGHTS/METERS/SWITCHES
R = Red
W = White
Y = Yellow
SPECIFICATIONS
12 V – 55 W
12 V – 55 W
12 V – 5 W x 2
12 V – 21/5 W x 2
12 V – 5 W
12 V – 21(/5) W x 2
12 V – 21 W x 2
12 V – 5 W
LED x 13
LED x 6
LED x 2
LED
LED
LED
LED
LED
LED
LED
LED
LED
40 A x 1
5 A x 4, 10 A x 5, 15 A x 4, 30 A x 1
40 A x 1
5 A x 5, 10 A x 5, 15 A x 4, 30 A x 4
22-3