Honda NSS250S Manual page 378

FINAL REDUCTION
ASSEMBLY
• Apply oil to each gear teeth and rolling area.
Clean the mating surfaces of the final reduction case
and left crankcase.
Pull the drive shaft into the bearing inner race in the
left crankcase until it is fully seated, using special
tools.
TOOLS:
Assembly shaft
Assembly collar
Apply grease to a new drive shaft oil seal lips and
outside surface.
Install the drive shaft oil seal in the left crankcase on
the drive shaft so that the depth from the left crank-
case surface is 0.5 – 1.0 mm (0.02 – 0.04 in), using
special tools.
TOOLS:
Assembly shaft
Assembly collar
Apply oil to the counter gear shaft teeth and journal.
Install the washer and counter gear shaft.
12-12
maxiscooter-club.ru
07965-VM00200
07YMF-FPB0100
07965-VM00200
07YMF-FPB0100
MATING SURFACES
ASSEMBLY COLLAR
ASSEMBLY SHAFT
OIL SEAL
WASHER
COUNTER GEAR SHAFT
0.5 – 1.0 mm
(0.02 – 0.04 in)