Honda NSS250S Manual page 125

If the oil level is below or near the lower level line
Other viscosities oil
on the dipstick, add the recommended oil to the
may be used
upper level.
depending upon the
average
RECOMMENDED ENGINE OIL:
temperature in your
Honda "4-stroke motorcycle oil" or an equivalent
riding area. Use the
Oil recommendation:
chart as a guide.
API classification: SG or higher
(except oils labeled as energy conserving on the
circular API service label)
Viscosity: SAE 10W-30
JASO T 903 Standard: MB
Check the O-ring for wear or damage, and replace it
if necessary.
Apply oil to the O-ring and install into the groove of
the oil filler cap/dipstick.
Install the oil filler cap/dipstick.
OIL CHANGE
Warm up the engine.
Change the oil with
Support the scooter on its center stand.
the engine warm
and the scooter on
Stop the engine, remove the oil filler cap/dipstick
its center stand to
and wipe oil from the dipstick with a clean cloth.
assure complete
and rapid draining.
Remove the oil drain bolt and sealing washer.
Drain the engine oil completely.
Clean the oil drain bolt and apply oil to the oil drain
bolt threads.
Install the drain bolt with a new sealing washer and
tighten it.
TORQUE: 25 N·m (2.5 kgf·m, 18 lbf·ft)
Pour the recommended oil into the crankcase to the
upper level line on the dipstick.
OIL CAPACITY:
1.3 liter (1.4 US qt, 1.1 Imp qt) after draining
1.4 liter (1.5 US qt, 1.2 Imp qt) after oil filter change
1.7 liter (1.8 US qt, 1.5 Imp qt) after disassembly
Check the oil level (page 4-10).
Make sure there are no oil leaks.
After change of the oil, reset the oil change indicator
(page 4-12).
maxiscooter-club.ru
OIL FILLER CAP/DIPSTICK
O-RING
OIL FILLER CAP/DIPSTICK
SEALING WASHER
MAINTENANCE
OIL DRAIN BOLT
4-11