Honda NSS250S Manual page 359

maxiscooter-club.ru
Install the snap ring into the groove in the driven
pulley face.
• Check that the snap ring is seated in the groove.
• Do not reuse the snap ring which could easily
spin in the groove.
Fill the inner face of the drive pulley face boss with
5.0 – 7.0 g (0.18 – 0.25 oz) of the grease.
Apply grease to a new needle nearing.
Install the needle bearing into the driven face
squarely with the marked side facing up as shown.
TOOLS:
Driver
Attachment, 32 x 35 mm
Pilot, 25 mm
INSPECTION
CLUTCH OUTER
Check the clutch outer for wear or damage.
Measure the clutch outer I.D.
SERVICE LIMIT: 135.5 mm (5.33 in)
CLUTCH SHOE LINING
Check the clutch shoe for wear or damage.
Measure the clutch shoe lining.
SERVICE LIMIT: 1.5 mm (0.06 in)
DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
07749-0010000
07746-0010100
07746-0040600
SNAP RING
BEARING
DRIVER/PILOT
ATTACHMENT
NEEDLE BEARING
11-31