Driven Pulley Sensor - Honda NSS250S Manual

Honda S Matic System (NSS250A)

DRIVEN PULLEY SENSOR

DRIVEN PULLEY SENSOR PLATE
REMOVAL/INSTALLATION
Remove the driven pulley (page 11-27).
Remove the bolts and driven pulley pulser ring.
Installation is in the reverse order of removal.
TORQUE:
Driven pulley pulser ring bolt:
9 N·m (0.9 kgf·m, 6.6 lbf·ft)
DRIVEN PULLEY SENSOR REMOVAL/
INSTALLATION
Remove the Driven pulley (page 11-27).
Disconnect the sub-harness 10P (Black) connector.
Remove the bolts and driven pulley sensor stay.
Remove the grommet from the left crankcase.
Remove the bolts and driven pulley sensor.
Installation is in the reverse order of removal.
24-60
maxiscooter-club.ru
SENSOR PLATE
BOLTS
10P CONNECTOR
STAY
BOLTS
DRIVEN PULLEY SENSOR
GROMMET
BOLTS