Honda NSS250S Manual page 349

maxiscooter-club.ru
Drive a new bearing into the holder squarely until it
is fully seated, using special tools.
TOOLS:
Driver
Attachment, 52 x 55 mm
Pilot, 22 mm
Install the snap ring to the screw holder groove.
• Check that the snap ring is seated in the groove.
• Do not reuse the snap ring which could easily
spin in the groove.
Install the screw holder and socket bolts.
Tighten the socket bolts to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
DISASSEMBLY/INSPECTION
Remove the movable drive face spline collar and oil
seal from the movable drive pulley face.
DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
07749-0010000
07746-0010400
07746-0041000
ATTACHMENT/PILOT
SNAP RING
SOCKET BOLTS
SCREW HOLDER
OIL SEAL
DRIVER
BEARING
SPLINE COLLAR
11-21