Honda NSS250S Manual page 356

DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
DISASSEMBLY/INSPECTION
CLUTCH/DRIVEN PULLEY DISASSEMBLY
Set the clutch/driven pulley assembly onto a special
tool by aligning the bosses with the holes in the
clutch.
TOOL:
Clutch spring compressor
Hold the clutch spring compressor in a vise.
Compress the clutch/driven pulley assembly and
To prevent loss of
remove the clutch/driven pulley nut using a special
tension, do not
tool.
compress the
clutch spring more
TOOL:
than necessary.
Socket wrench, 39 x 41 mm
Loosen the clutch spring compressor gradually and
disassemble the following:
– Clutch assembly
– Seal collar
– Driven pulley face spring
– Spring seat
– Spring guide collar
– Driven pulley assembly
CLUTCH DISASSEMBLY
Remove the E-clips and side plate.
11-28
maxiscooter-club.ru
07LME-GZ40201
07GMA-KS40100
CLUTCH/DRIVEN PULLEY ASSEMBLY
CLUTCH SPRING COMPRESSOR
DRIVEN PULLEY NUT
DRIVEN PULLEY ASSEMBLY
SPRING SEAT
SPRING GUIDE
COLLAR
SPRING CLUTCH ASSEMBLY
E-CLIPS
SOCKET WRENCH
SEAL COLLAR
SIDE PLATE