Actuator - Honda NSS250S Manual

maxiscooter-club.ru
Measure the voltage between the actuator 2P con-
nector of the wire side and ground.
CONNECTION: Red/white (+) – Ground (–)
There should be battery voltage at all time.
Push the registered card key system ON/OFF switch
ON and Put it within the operating range.
Check the continuity between the actuator 2P con-
nector of the wire side and ground.
CONNECTION: Green/blue (+) – Ground (–)
There should be continuity for a moment with each
release button pushed.
REMOVAL/INSTALLATION
Remove the inner cover (page 3-27).
Disconnect the console box lock release actuator 2P
(Gray) connector.
Remove the trim clip and front actuator cover.
Honda Smart Card Key System
ACTUATOR 2P CONNECTOR
(Wire side/female terminals)
Red/white
ACTUATOR 2P CONNECTOR
(Wire side/female terminals)
Green/blue
2P CONNECTOR
TRIM CLIP
ACTUATOR COVER
23-33