Honda NSS250S Manual page 476

HYDRAULIC BRAKE
RIGHT BRAKE LINE
Connect a commercially available brake bleeder to
the upper bleed valve of the front caliper.
• Follow the manufacturer's operating instruc-
tions.
Loosen the front brake caliper upper bleed valve
If an automatic refill
and perform the bleeging procedure until the sys-
system is not used,
tem is completely flushed/bled.
add fluid when the
fluid level in the
Tighten the front brake caliper upper bleed valve to
reservoir is low.
the specified torque.
TORQUE: 5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
After bleeding air, operate the right brake lever. If it
still feels spongy, bleed the system again.
Fill the reservoir with DOT 4 brake fluid to the upper
level.
If the brake bleeder is not available, perform the fol-
lowing procedure:
Close the upper bleed valve and fill the reservoir
with DOT 4 brake fluid to the upper level.
Operate the right brake lever several times to bleed
Check the fluid
air from the master cylinder.
level often while
bleeding the brakes
to prevent air from
being pumped into
the system.
17-10
maxiscooter-club.ru
NSS250A shown:
UPPER BLEED VALVE
NSS250A shown:
RIGHT BRAKE LEVER
BRAKE BLEEDER
UPPER LEVEL