Honda NSS250S Manual page 361

ASSEMBLY
• Apply specified quantity of grease to the inside
of the driven pulley face and the guide grooves
in the movable driven pulley face.
• Avoid getting grease or oil on the clutch shoe lin-
ings and driven pulley faces. Discard contami-
nated clutch shoes and clean contaminated
pulley faces with a high quality degreasing
agent.
GUIDE ROLLER PIN
GUIDE ROLLER
DRIVEN PULLEY FACE
OIL SEAL
MOVABLE DRIVEN PULLEY FACE
NEEDLE BEARING
SNAP RING
BEARING
DRIVEN PULLEY ASSEMBLY
Clean the driven faces thoroughly.
Apply grease to new oil seal lips and install them
into the movable driven pulley face.
Coat new O-rings with oil and install them into
grooves in the movable driven pulley face.
maxiscooter-club.ru
E-CLIPS
DUMPER RUBBERS
OIL SEAL
O-RINGS
DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
CLUTCH SIDE PLATE
SHOE SPRINGS
CLUTCH SHOE
SEAL COLLAR
SPRING GUIDE COLLAR
DRIVEN PULLEY FACE SPRING
O-RINGS
DRIVE PLATE
79 N·m (8.1 kgf·m,
58 lbf·ft)
SPRING SEAT
OIL SEALS
11-33