Honda NSS250S Manual page 627

maxiscooter-club.ru
HANDLE LOCK MODULE POWER
CIRCUIT INSPECTION (WITH TEST
PROBE)
Remove the inner cover (page 3-27).
Turn the ignition switch OFF.
Disconnect the handle lock module 21P (Black) con-
nector (page 23-26).
Measure the voltage between the handle lock mod-
ule 21P connector of the wire side and ground using
a special tool.
TOOL:
Test probe
CONNECTION: Black/white (+) – Ground (–)
Red/white (+) – Ground (–)
There should be battery voltage when the ignition
switch is turned ON.
If there is no voltage, check for open or short circuit
in Black/white and/or Red/white wire.
Turn the ignition switch OFF.
Check the continuity between the handle lock mod-
ule 21P connector of the wire side and ground.
CONNECTION: Green – Ground
Green/black – Ground
There is continuity if the system is normal.
If there is no continuity, check for open circuit in
Green and/or Green/black wire.
HANDLE LOCK MODULE POWER
CIRCUIT INSPECTION (WITH TEST
HARNESS)
Connect the test harness 21P between the handle
lock module 21P (Black) connector and main har-
ness (page 23-17).
Measure the voltage between the test harness and
ground.
CONNECTION: 14 (+) – Ground (–)
15 (+) – Ground (–)
There should be battery voltage when the ignition
switch is turned ON.
If there is no voltage, check for open or short circuit
in Black/white and/or Red/white wire.
HANDLE LOCK MODULE 21P CONNECTOR
(Wire side/female terminals)
Black/white
07ZAJ-RDJA110
HANDLE LOCK MODULE 21P CONNECTOR
(Wire side/female terminals)
TEST HARNESS 21P
Honda Smart Card Key System
Green/black Green
(15) (14)
Red/white
23-21