Engine Oil Filter - Honda NSS250S Manual

Hide thumbs Also See for NSS250S:
Table of Contents

Advertisement

MAINTENANCE
ENGINE OIL CHANGE INDICATOR
INSPECTION
• The oil change indicator appears in the display
when the mileage hours on this scooter
approaches the oil change interval specified on
the maintenance schedule.
• Reset the indicator after each oil change.
To reset the indicator, press and hold the reset but-
ton then ignition switch ON.
Keep the reset button pressed for three seconds.
The indicator will disappear.
If the oil is changed before the oil change indicator
appears, be sure to reset the oil change indicator
after changing the oil.
The indicator will appears for two seconds, then dis-
appear.
This means the indicator is reset.

ENGINE OIL FILTER

REPLACEMENT
Change the oil with engine warm and the scooter on
its center stand to assure complete and rapid drain-
ing.
Start the engine, warm it up and stop it.
Drain the engine oil from the crankcase (page 4-11).
Remove the oil filter cartridge using a special tool
and let the remaining oil drain out.
TOOL:
Oil filter wrench
Check that the length from the boss head to the
crankcase surface is within specifications.
STANDARD: 16.0 mm (0.6 in)
When removing the oil filter boss, apply locking
agent to the oil filter boss threads.
Install the oil filter boss and tighten it to the speci-
fied torque.
TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)
After tightening the oil filter boss, check that the
length from the boss head to the crankcase surface
is within specifications.
4-12
maxiscooter-club.ru
07HAA-PJ70101
NSS250A shown:
OIL CHANGE INDICATOR
RESET BUTTON
OIL FILTER CARTRIDGE
OIL FILTER WRENCH
OIL FILTER BOSS
16.0 mm (0.6 in)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nss250a

Table of Contents