Honda NSS250S Manual page 245

maxiscooter-club.ru
10.Check if the MIL blinks.
If the MIL begins short blink (0.3 seconds), the
throttle valve fully closed position is reset.
• If the MIL stays lit, the throttle valve fully closed
position is not reset, repeat the reset procedure
from step 3.
MIL ON
OFF
IGNITION SWITCH ON
11.Turn the ignition switch OFF.
12.Connect the ECT sensor 3P (Gray) connector.
13.Remove the battery (page 19-6).
14.Install the luggage lower box (page 3-16).
15.Disconnect the DLC from the SCS connector.
Install the dummy connector.
16.Install the battery cover (page 19-6).
17.Support the scooter on its center stand.
Start the engine, let it idle and check the engine
revolution.
STANDARD: 1,500 ± 100 min
• If the engine revolution is out of specification,
check the following:
– Throttle operation (page 4-5)
– IACV (page 6-103)
– Intake air leak
within 10 sec.
0.1 sec.
1.3 sec.
RESET RECEIVING PATTERN
3P (Gray) CONNECTOR
NSS250A shown:
-1
(rpm)
DUMMY CONNECTOR
FUEL SYSTEM (PGM-FI)
0.3 sec.
0.3 sec.
SUCCESSFUL PATTERN
SCS CONNECTOR
6-91