Honda NSS250S Manual page 460

REAR WHEEL/PARKING BRAKE/SUSPENSION
Drive in a new bearing into the swingarm squarely
The marked side of
until it is fully seated, using special tools.
the bearing is
facing to the special
TOOLS:
tools.
Driver
Attachment, 42 x 47 mm
Pilot, 17mm
Install the snap ring into the groove of the swing-
Install the snap ring
arm securely.
with its chamfered
edge facing the
• Check that the snap ring is seated in the groove.
thrust load side.
• Do not reuse the snap ring which could easily
spin in the groove.
Apply grease to a new dust seal lips and outer sur-
face.
Install a new dust seal to the swingarm until the
dust seal is flush with the swingarm.
16-10
maxiscooter-club.ru
07749-0010000
07746-0010300
07746-0040400
DRIVER
SNAP RING
DUST SEAL
ATTACHMENT/
PILOT
BEARING