Honda NSS250S Manual page 508

ABS (NSS250A)
PROBLEM CODE INDICATION PATTERN
• The ABS indicator indicates the problem code by blinking a specified number of times.
The indicator has two types of blinkings, a long blink and short blink. The long blink lasts for 1.3 sec-
onds, the short blink lasts for 0.3 seconds. When two long blinks occur, and three short blinks, that
problem code is 23 (two long blinks = 20 blinks, three short blinks = 3 blinks). Then, go to trouble-
shooting and see problem code 23.
• When the ABS control unit stores six problem codes, the ABS indicator shows the problem codes in
the order from the latest problem code to earliest problem code.
ON
IGNITION
SWITCH
OFF
ON
ABS
INDICATOR
OFF
When the problem code is not stored:
ON
ABS
INDICATOR
OFF
PROBLEM CODE READOUT
• The problem code is not erased by turning the ignition switch OFF while the problem code is being
output. Note that turning the ignition switch ON again does not indicate the problem code. To show
the problem code again, repeat the problem code retrieval procedures from the beginning. Do not
apply the front or rear brake during retrieval.
• After diagnostic troubleshooting, erase the problem code(s) and pre-start self-diagnosis to be sure
that there is no problem in the ABS indicator (indicator is operating normally).
1. Remove the battery cover (page 19-6).
Turn the ignition switch OFF.
Short the wire terminals of the ABS service check
3P connector with a jumper wire.
CONNECTION: Brown/white – Green/black
18-8
maxiscooter-club.ru
1.3 sec.
2 sec.
3.6 sec.
Problem code
start signal
0.4 sec.
Lowest number problem code
(Example : Code 12)
2 sec. 3.6 sec.
1.3 sec.
1.3 sec.
0.3 sec.
3.6 sec. 0.5 sec.
Highest number problem code
(Example : Code 23)
ABS SERVICE CHECK 3P CONNECTOR
Pattern repeated
Green Brown
/white
/black
JUMPER WIRE