Console Box - Honda NSS250S Manual

FRAME/BODY PANELS/EXHAUST SYSTEM

CONSOLE BOX

REMOVAL/INSTALLATION
Open the console box.
Open the console box fully by pushing it forward
about half of travel and pulling out the console box
slowly.
Push the console box lightly and slide the pin to left,
then pull out the console box from the rail.
Install and close the console box.
Align the pin with
groove.
• When installing the console box, make sure that
the console box lock release switch of the con-
sole box locked and unlocked.
DISASSEMBLY/ASSEMBLY
LEFT INNER BOX
Remove the screw and spring.
Remove the lock pin cap, E clip, washer, wave
washer, collar and lock pin.
Remove the screws and left inner rail.
Remove the screws and left inner box lid.
INNER BOX LID
Assembly is in the reverse order of disassembly.
TORQUE:
Left inner rail screw:
1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)
Left inner box lid screw:
1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)
3-24
maxiscooter-club.ru
CONSOLE BOX
SCREWS 4 x 12
SCREWS 4 x 12
SCREWS 4 x 16
LEFT INNER RAIL
RAILS
PIN
PIN
LOCK PIN CAP
E CLIP
WASHER
WAVE WASHER
COLLAR
SPRING
CONSOLE BOX
LOCK PIN
LEFT INNER RAIL