Siemens HiPath 3000 Series Service Documentation page 586

inst_h3.fm
Installing HiPath 3000
Installing HiPath 3800
Table 4-6 HiPath 3800 - Assignment of Connectors and Jacks on the Backplane of the
Basic Cabinet
Connector
X101 – X105 SIVAPAC connector for connecting peripherals:
CABLUs and open-end cables are used for connection to the MDFU-E or to
X109 – X112
an external patch panel (see Section 4.1.6.4).
Note: The SIVAPAC connectors can have the following connector panels:
●
●
●
X116 SIVAPAC connectors for picking up the signals from the REALS board.
CABLUs for connection to the MDFU-E (jumper strip for 25 TW):
●
●
Open-end cable (24 TW) for connection to an external patch panel:
●
●
●
●
●
X201 68-pin DB68 mini-jack for connecting the cable C39195-Z7611-A10 to the ex-
pansion cabinet (for the
X209 DC port
X211, X212 AC power
X214 10-pin connection for the ring voltage generator RGMOD (for selected coun-
tries only)
4-54
Connector panels with RJ45 jacks for direct connection of peripherals
(see Section 4.1.6.5).
For U.S. only: Connector panels with CHAMP jack for direct connection
of peripherals (see Section 4.1.6.6).
Connector panels each with two SIPAC 1 SU connectors for connecting
an external main distribution frame or external patch panel using CABLUs
(see Section 4.1.6.7).
C39195-A7267-A372: 3 m in length, short stripped length for MDFU-E
slots 11-21 (see Figure 4-36)
C39195-A7267-A373: 3 m in length, long stripped length for MDFU-E
slots 1-10 (see Figure 4-36)
S30267-Z196-A150: 15 m in length
S30267-Z196-A250: 25 m in length
S30267-Z196-A350: 35 m in length
S30267-Z196-A550: 55 m in length
S30267-Z196-A950: 95 m in length
Function
DBSAP board)
HiPath 3000/5000 V9, Service documentation
Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012