Event Log For Hipath 3000; Testing Telephones - Siemens HiPath 3000 Series Service Documentation

Table of Contents

Guided Maintenance

Event log for HiPath 3000

HiPath 3000 features an event log where accrued errors are classified according to error class

and error number with the date/time of the original error. You can use HiPath 3000/5000 Man-

ager E to read out the event log.

Section 12.4.16 contains information on the possible entries.

After startup and country adaptation, you can activate the terminal test on any optiPoint 600

office (in U

mode), OpenStage, optiPoint 410 and optiPoint 420 telephone using a code or

the service menu.

It is not possible to perform the terminal test on optiPoint 410 S and optiPoint 420 S telephones.

This test checks the display (your number is displayed), LEDs, and ring tones. The tests ends

automatically after a period of time. The test allows you to perform a visual and acoustic check

of the components to ensure that they are functioning properly.

Test procedure on the system telephone

If the test does not react as described, an additional power supply (plug-in power

supply unit) for the relevant system telephone may be necessary.

The phone number, date and time are normally shown in the display. If a different text appears

("Gateway not found", for example), this means that there is an error.

Correct the error by following the administration instructions for the relevant telephone.

Code for terminal test

For approximately five seconds, all LEDs blink quickly (ex-

cept for the Service menu LED), all display pixels are acti-

vated, and you can hear a tone.

Nur für den internen Gebrauch

A31003-H3590-S100-7-7620, 06/2012

HiPath 3000/5000 V9, Service documentation

Show Quick Links

Table of Contents