Siemens HiPath 3000 Series Service Documentation page 632

inst_h3.fm
Installing HiPath 3000
Installing HiPath 3550, HiPath 3350, HiPath 3500, and HiPath 3300
HiPath 3550 - MDFU connections for peripheral board
Figure 4-54 HiPath 3550 - Backplane connection for peripheral board
Not for U.S.: HiPath 3550: Connecting the Cabling
If
SLA8N Route the 16 TW to the MDFU via the SU X8 and 8 TW via SU X9 (see
SLA16N Figure 4-54) using a standard cable (with 16 TW). Connect both cables (= 1
SLA24N CABLU with SU connectors labeled 8 and 9) to the same jumper strip (25
SLC16N TW).
SLMO24
Slot with any
●
other periph-
eral board
●
4-100
The two arrows on the left mark the con-
nections for the cables coming from the
main distribution frame (MDFU).
Without an external main distribution frame (MDFU):
You can attach cables for the peripheral boards directly to the boards (see
Figure 4-55 for the slip-on connectors) and route them to the MDFU
through the cable duct inside the housing.
With an external main distribution frame (MDFU):
Use CABLU S30269-Z41-A30 (Figure 4-53) to connect the peripheral
boards to the customer's line network. As shown in Figure 4-55, you can
connect the eight-pin slip-on connectors to the boards directly. The line
network connects directly to the jumper strip.
Nur für den internen Gebrauch
Then
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation