Siemens HiPath 3000 Series Service Documentation page 749

Nur für den internen Gebrauch
Table 7-3 HiPath 3300 as a GW, Procedure for System Installation and Startup
Step
8. Making Trunk Connections
Refer to the following board descriptions for information:
STLS4R - for S
●
Note: Analog workpoint clients can be connected to the CBRC's T/R ports in emer-
gencies. This ensures telephone operation via the telecommunications network in
the event of IP network failure.
9. Making IP connections
Perform the IP connection over the HG 1500 board, HXGR3.
For information on configuration, refer to the HG 1500 Administration Manual.
10. Performing a Visual Inspection, page 4-123
Startup of HiPath 3300 (Section 5.2)
1. Supplying the System With Power, page 5-12 (starting system boot).
Note (for Brazil only): The AC power of the system is internally equipped with tran-
sient overvoltage protection up to approx. 2 kV. Since additional lightning protec-
tion is prescribed for Brazil, the AC power of the system must be conducted through
the outlet strip with overvoltage protection (part number C39334-Z7052-C33). In
this way, transient overvoltage protection is guaranteed up to approx. 4 kV.
2. Carrying Out a System Reload, page 5-15
3. Carrying Out the Country Initialization and Selecting the Password Type, page 5-15
4. Not for U.S.: Entering the System Number, page 5-17
5. Conducting customer-specific programming with HiPath 3000/5000 Manager E.
Refer to the HiPath 3000/5000 Manager E Help for information on programming in-
dividual features.
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Activity (Remarks)
trunk connection
0
Starting HiPath 3000 as a Gateway
Starting HiPath 3300 as a Gateway
start_3g.fm
7-9