Siemens HiPath 3000 Series Service Documentation page 438

boards.fm
Boards for HiPath 3000
Peripheral boards
Settings
Table 3-146 TMCAS-2 (for selected countries only) – Jumper Functions
Jumper
X11 Sets the V.24 baud rate
X12
X14
X13 Deletes the flash mem-
X16 Resetting the card
X17 Hardware watchdog
X24 Sets trunk impedance
for CAS interface 1
X25 Sets trunk impedance
for CAS interface 2
X999 Grounding: card / CAS
Table 3-147 TMCAS-2 (for selected countries only) – Jumper for Setting the V.24 Baud
Rate
V.24 baud rate
(Kbps)
9.6
(default setting)
19.2
38.4
57.6
115.2
9.6
3-306
Function
Flash memory is deleted
ory (all sectors apart from U-
Grounding for the card is
cable connected to the ground-
X11
Open
Open
Closed
Open
Closed
Pins 1–2 closed
See Table 3-147
boot (firmware)).
Reset performed.
Watchdog active.
(default setting)
75 ohms
(default setting)
75 ohms
(default setting)
ing for the CAS cable.
Jumper
X12
Open
Open
Open
Closed
Closed
All other configurations
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Nur für den internen Gebrauch
Setting
Pins 2–3 closed
Flash memory is not de-
leted.
(default setting)
Reset not performed.
(default setting)
Watchdog not active.
120 ohms
120 ohms
Grounding for the card is
not connected to the
grounding for the CAS
cable.
(default setting)
X14
Open
Closed
Closed
Closed
Closed