Table of Contents
Advertisement
boards.fm
Boards for HiPath 3000
Peripheral boards
3.3.42
TMGL4 (for U.S. only)
NOTE
>
Danger of damage to property due to surge voltage. The required lightning protec-
tion measures must be taken for this board, see Section 2.1.2, "Lightning Protec-
tion".
Introduction
A TMGL4 trunk module connects up to four analog ground-start or loop-start trunks to HiPath
3550 and HiPath 3350.
Ground start is the default.
Warning
7
You must disconnect the power and remove the slip-on connectors from the TMGL4
board before removing it from the system.
Do not connect the slip-on connectors to the TMGL4 board until the board is seated
in its slot and the system power is on.
Failure to follow these instructions may severely damage the system.
Interfaces
To trunks
To ANI4
Figure 3-114
TMGL4 (for U.S. only) - Interfaces (S30810-Q2918-X)
3-334
1
TMGL4 board
X2
8
X3
Nur für den internen Gebrauch
50
X1
2
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
To CUP/
CUC
Hide quick links:
Advertisement
Table of Contents
