Diut2 - Siemens HiPath 3000 Series Service Documentation

boards.fm
Boards for HiPath 3000
Peripheral boards
3.3.3

DIUT2

Introduction
HiPath 3000/5000 V7 Minor Release 5 and higher supports the use of the DIUT2 board (Digital
Interface Unit Trunk 2) in HiPath 3800.
The DIUT2 board is a compatible successor to the following boards:
DIU2U (S30810-Q2216-X) (for U.S. only)
●
DIUN2 (S30810-Q2196-X)
●
The board features two ports for the following:
S trunk connection (over NT)
●
2M
S networking via S
●
2M
T1-PRI (Primary Rate Interface) trunk connection (for U.S. only)
●
T1 analog trunk connection (for U.S. only)
●
A total of up to three DIUT2 and/or DIUN2 boards can be installed in a system. When used as
a T1 trunk connection (PRI or analog), a system can accommodate up to four DIUT2 and/or
DIU2U boards.
Not for U.S.: The B channels associated with the DIUT2 board require a license. In-
>
formation on licensing can be found in Chapter 8, "Licensing".
3-88
lines
2M
Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation