Siemens HiPath 3000 Series Service Documentation page 688

start_h5.fm
Startup and Administration HiPath 5000
Software Structure
The following table shows the most important features of the Feature Server.
Table 6-1 Feature Server Components
Component
vsrv.exe
vaplx.dll
cars.exe
regserv-
er.exe
vsync.exe
FCT.dll
Presence Manager
This is a Feature Server service for signaling the call processing station states "free", "busy"
and "call" using the LEDs on the optiPoint telephones in a HiPath 3000/5000 network. You can
pick up a call by pressing the appropriate button.
Call processing states can only be signaled for a station if the Presence Manager can set a
CSTA monitor point on the relevant station. The status of a MULAP call number cannot be sig-
naled, for example, because a CSTA monitor point cannot be set on a call number of this type.
The dssserver.exe service for the Presence Manager is installed with the HiPath 5000 software.
This is a user-configured service that receives its information from vaplx.dll. The TAPI Ser-
vice Provider is required for the Presence Manager to work.
Note for troubleshooting and diagnosis
>
The Feature Server and Presence Manager components generate entries in the
Event Viewer (event log) which are used for troubleshooting and diagnosis. Section
12.4.17 provides information on the possible entries and any necessary user re-
sponses.
6-6
Basic Feature Server component. As an MS Windows service, it starts all
other components.
Logical interface for applications. Provides read-only and read/write access
to CDB data.
The Call Address Resolution Server provides the HG 1500 boards with the
call numbers of all HiPath 3000 systems (nodes) that belong to the net-
work.
Note: Event 1027 confirms that the corresponding HG 1500 board was suc-
cessfully downloaded with the call numbers of all HiPath 3000 systems as-
sociated with the network Section 12.4.17).
Following startup, the HG 1500 boards automatically log on to the Feature
Server over the Registration Server.
All "node-specific" CDB changes (for example, by key programming, Assis-
tant T) are reported by the node to the Feature Server's VSYNC process.
This ensures the automatic synchronization of the Feature Server with the
new CDB data.
Interface to the systems for direct CDB data access.
Nur für den internen Gebrauch
Function
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation