For U.s. Only: Power Plug - Siemens HiPath 3000 Series Service Documentation

Nur für den internen Gebrauch
Information on the design can be found in the following sections:
HiPath 3550 Section 2.1.4.2
●
HiPath 3350 Section 2.1.4.3
●
4.2.3.1.1

For U.S. only: Power plug

The AC connection must fulfill the requirements specified in Table 4-11.
Table 4-11 Electrical Connection Values (for U.S. only)
Nominal Nominal voltage range
voltage
from
120 V AC/ 110 V AC
60 Hz
AC Outlet Requirements
The power source may not be more than 2 m (6 ft.) from the system.
●
The power source must supply a voltage of 120 V AC (single phase, fused) in 50-60 Hz.
●
A warning should be attached to the circuit breaker to prevent accidental removal of power.
●
An independent electric circuit with an isolated ground conductor should be used.
●
Recommendation: Add a power surge protector between the AC outlet and the system.
●
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Installing HiPath 3550, HiPath 3350, HiPath 3500, and HiPath 3300
Nominal Frequency
to from
130 V AC 47 Hz
Wall Outlet Configura-
Range
to
63 Hz NEMA 5-15, 2-pin, 3-
wire, earth
inst_h3.fm
Installing HiPath 3000
tions
4-89