Table of Contents
Advertisement
Nur für den internen Gebrauch
Switches and display
25-pin SUB-D jack:
V24 interface for connecting the
service PC with the ECGM tool
(position = free, factory default)
Figure 3-100
TMCAS (S30810-Q2938-X)
Administration of the CAS protocol converter
Use the ECGM tool for administration. For information on installing the software on the service
PC and on the required settings, see Page 3-301.
You can use the C39195-Z7267-C13 cable for the connection between jack X10 and the ser-
vice PC.
Switches S4-1 to S4-4 for setting the impedance
To ensure that the TMCAS works properly, the same impedance must be selected both on the
S
side of the TMCAS and on the
2M
Impedance on the CAS Side
120 ohms (default)
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Display
Lockout switch
TS2N
H1
X10
S1
Off
= default
(HiPath 3550) board.
Switch settings
S4-1
Off
Boards for HiPath 3000
Peripheral boards
Battery
Switch S4
1
Jumper
S2
3 2 1
S3
S4-2
Off
boards.fm
3-295
Hide quick links:
Advertisement
Table of Contents
