Starting Hipath 3300 As A Gateway; Prerequisites; Procedure For Installation And Startup - Siemens HiPath 3000 Series Service Documentation

start_3g.fm
Starting HiPath 3000 as a Gateway

Starting HiPath 3300 as a Gateway

7.3 Starting HiPath 3300 as a Gateway
7.3.1

Prerequisites

Warning
7
Only authorized service personnel should install and start up the system.
Refer to Section 4.2.1 for information on the tools and resources needed to install the HiPath
3300 system.
7.3.2

Procedure for Installation and Startup

To ensure that IP addresses are not assigned more than once in the customer net-
>
work, you must ping each new IP address to be configured before each IP address
is assigned. If an IP address responds, then this address cannot be used again.
Caution (for Brazil only)
7
The use of the outlet strip with overvoltage protection with part number C39334-
Z7052-C33 is absolutely mandatory. The AC power of the system must be conduct-
ed through the outlet strip with overvoltage protection.
Table 7-3 HiPath 3300 as a GW, Procedure for System Installation and Startup
Step
HiPath 3300 Installation (19-Inch Cabinet) (Section 4.2)
1. Selecting the Installation Site, page 4-111 (usually predetermined)
2. Unpacking the Components, page 4-112
3. Not for U.S.: Attaching a HiPath 3500 and HiPath 3300 to the Wall, page 4-113
4. Installing a HiPath 3500 or HiPath 3300 in a Cabinet, page 4-114
5. Grounding the System, page 4-116
6. Connecting Cables and the Line Network, page 4-118
7. Configuration Notes, page 4-120
7-8
Activity (Remarks)
HiPath 3000/5000 V9, Service documentation
Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012