Siemens HiPath 3000 Series Service Documentation page 440

boards.fm
Boards for HiPath 3000
Peripheral boards
Seven-segment display
The card's software status can be ascertained on the basis of the seven-segment display. For
this a distinction is made between the following boot phases:
Power supply unit switched on
U-boot U-boot
(Firmware) (Firmware)
Linux operating system
Initializing
CAS application software
U-boot (firmware) states
●
Table 3-148
Display
3-308
TMCAS-2 (for selected countries only) – U-boot (firmware) States
Initializing hardware
Downloading DSP (Digital Signal Processor) firmware
Downloading FPGA (Field Programmable Gate Array) firmware
Accessing flash EPROM (Save and Delete)
Activating built-in self test BIST (BIST1 or BIST2)
Administration (Service PC connected)
Copying software (from SDRAM to FEPROM)
The decimal point is flashing to indicate that the U-
boot firmware is operational.
The decimal point is activated (not flashing) to indi-
cate initialization of the Linux operating system.
The decimal point is activated when the card sup-
plies the clock reference for the system.
Meaning
HiPath 3000/5000 V9, Service documentation
Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012