Siemens HiPath 3000 Series Service Documentation page 1010

service.fm
Service
Service and Maintenance Tasks
The IP workpoint clients in the Small Remote Sites (branches) should use the same call
●
numbers in normal mode (registered with HiPath 4000) and in emergency mode (regis-
tered with HiPath 3000).
In this case, the call numbers are assigned via HiPath User Management.
When configuring the IP workpoint clients (system clients) via HiPath 3000/5000 Manager
E their call numbers should be deleted. Otherwise it is not possible to assign call numbers
via HiPath User Management without taking further steps.
The IP workpoint clients in the Small Remote Sites (branches) should use different call
●
numbers in normal mode (registered with HiPath 4000) and in emergency mode (regis-
tered with HiPath 3000).
In this case, the call numbers are assigned via HiPath 3000/5000 Manager E when config-
uring the IP workpoint clients (system clients).
An IP workpoint client configured in this way can then be assigned a HiPath 4000 call num-
ber for normal mode via HiPath User Management.
The following configuration data for an IP workpoint client is modified via HiPath User Manage-
ment:
Internal call number
●
DID number
●
Directory name
●
CFSS destination
●
Access groups
●
Refer to the HiPath User Management service and administrator documentation for
>
information on the installation and configuration procedures for HiPath 3000/5000
and HiPath 3000 Element Manager.
12-36
Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation