Table of Contents
Advertisement
boards.fm
Boards for HiPath 3000
Options
3.4.3
ANI4 (for selected countries only)
NOTE
>
Danger of damage to property due to surge voltage. The required lightning protec-
tion measures must be taken for this board, see Section 2.1.2, "Lightning Protec-
tion".
Introduction
The ANI4 (Automatic Number Identification) board is responsible for receiving station numbers
modulated using the CPFSK method, demodulating them, and forwarding them to the base
system HiPath 3550 and HiPath 3350. In V4.0 SMR-7 or later, the station name is analyzed in
addition to the call number and shown on the telephone display.
Each ANI4 can serve four trunks. It contains the external trunk board hardware interfaces
(TMGL4) as well as a trunk and options bus interface. The trunks are transferred directly on the
board between the trunk and the trunk board interfaces.
Interfaces on the ANI4 module
TMGL4
Trunk
*) Pins: Component side/solder side
Figure 3-129
ANI4 (for selected countries only) - Interfaces (S30807-Q6917-Axxx)
LED statuses and their meanings
On the ANI4 board two LEDs are implemented that show the status of trunk channel 1.
After system startup the green LED is on and the red LED is off. This signals that the layer-1
firmware has started correctly.
3-360
LEDs
2/1
(green)
4/3
X 3 *)
6/5
8/7
10/9
1
X 4
8
CBside
(red)
ANI4
Board side
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Nur für den internen Gebrauch
X 1
X 2
Hide quick links:
Advertisement
Table of Contents
