inst_h3.fm
Installing HiPath 3000
Installing HiPath 3800
4.1
Installing HiPath 3800
4.1.1
Installation Prerequisites
Warning
7
Only authorized service personnel should install and start up the system.
Tools and resources needed
The following are needed for installing the HiPath 3800 system:
Tools:
●
–
Hex or open-end wrench, 8 mm, open-end wrench 13 mm
–
Diagonal cutting pliers, telephone pliers, wire stripper, flat-nosed pliers
–
Slotted screwdrivers, from 2 to 8 mm (1/4 to 5/16 in.)
–
Phillips or cross-point screwdrivers, sizes 1 and 2
–
TORX screwdriver
–
Wire stripper (for example, from Krone)
–
Board wrench (part no. C39300-A7194-B10)
–
Electric drill, hammer
–
Level, tape measure
–
For U.S. only: Punch-down tool suitable for the block used (such as block 66)
Resources:
●
–
Assistant T or HiPath 3000/5000 Manager E
–
Digital multimeter for testing ground connections and partial voltages
–
Telephone test set for analog interfaces
–
Not for U.S.: ISDN tester (such as K3000 or Aurora)
–
For U.S. only: Aurora
er
4-2
Duet
Expert,
, Aurora
Aurora
Nur für den internen Gebrauch
Remote
or similar, ISDN protocol analyz-
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation