Siemens HiPath 3000 Series Service Documentation page 787

Nur für den internen Gebrauch
Table 9-1 Startup Rules for Inserting and Removing Boards
If
Replacing board with
over-equipped board
of same type
Replacing with a dif-
ferent board type
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Board is activated. The old station range is activated and the ports as-
sociated with the new board are inserted at the end. The ports are split
if there is no contiguous station range available.
In the case of subscriber line modules, you can use HiPath 3000/5000
Manager E to retain the old station data by copying it to the new board,
or you can delete it and reset the default state. Copying is not possible
for trunk boards.
The system does not automatically activate the board.
After removing the old board, you can delete it from the database us-
ing HiPath 3000/5000 Manager E or Assistant T.
After you have inserted the new board, the system activates it as if it
had been inserted into a free slot. However, the CDB area used by the
old board is left as a gap.
In the case of subscriber line modules, you can use HiPath 3000/5000
Manager E to retain the old station data by copying it to the new board,
or you can delete it and reset the default state. Copying is not possible
for trunk boards.
Expanding and Upgrading HiPath 3000
HiPath 3000Expanding
Then
exup.fm
9-3