Edge-Core ECS4660-28F Management Manual page 1470

| Multicast Filtering Commands
C 43
HAPTER
MLD Filtering and Throttling
ipv6 mld filter
(Global Configuration)
Table 191: MLD Filtering and Throttling Commands (Continued)
Command Function
show ipv6 mld filter Displays the MLD filtering status
show ipv6 mld profile Displays MLD profiles and settings
show ipv6 mld Shows if the interface is configured to drop MLD query
query-drop packets
show ipv6 mld throttle Displays the MLD throttling setting for interfaces
interface
This command globally enables MLD filtering and throttling on the switch.
Use the no form to disable the feature.
S
YNTAX
[no] ipv6 mld filter
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
MLD filtering enables you to assign a profile to a switch port that
◆
specifies multicast groups that are permitted or denied on the port. An
MLD filter profile can contain one or more, or a range of multicast
addresses; but only one profile can be assigned to a port. When
enabled, MLD join reports received on the port are checked against the
filter profile. If a requested multicast group is permitted, the MLD join
report is forwarded as normal. If a requested multicast group is denied,
the MLD join report is dropped.
◆ MLD filtering and throttling only applies to dynamically learned
multicast groups, it does not apply to statically configured groups.
The MLD filtering feature operates in the same manner when MVR6 is
◆
used to forward multicast traffic.
E
XAMPLE
Console(config)#ipv6 mld filter
Console(config)#
R C
ELATED OMMANDS
show ipv6 mld filter
– 1470 –
Mode
PE
PE
PE
PE